Seeing a picture of the signal levels would help. See here how to upload a image or use Imgur.
PS. It would be nice if a moderator made that post a sticky.
Thanks for the response. I hope this is what you meant.
Can't see all the downstream channels in that picture, but from what I do see, it looks good. Any downstream channels not locked or below -5dB or a SNR below 36?
Also, I notice you only have 4 upstream channels. That must be because your either in a new area with upstream OFDM or on a old node like in Florida or Louisiana with only 4 QAM upstream. Do you see any other section for upstream OFDM/OFDMA AKA "other" modulation?
What would be really nice to see is the event logs, but I don't think the gateway shows them. I believe some Tier 2 (CAG) reps. can see them though. What you would mostly be looking for is T3/T4 errors.
I checked and all of the downstream channels are locked. None show a negative or sub -5 dB, and all of my SNR show 37 or above. One thing out of place I found is that most of the channel frequencies show as ###MHz, but 159 just shows "300000000"
And yes, we are out in Louisiana. Small town, so likely older infrastructure. I'm not seeing any other sections that look like what you're describing.
Event logs are totally blank on my end, unfortunately. I have asked a few of the reps/techs I have talked to if they can look at event logs at specific times (which I have unfortunately forgotten now), but they typically ignore the question.
