Want to learn how to use the Support Forums?
Read the forum guidelines
For the past two months, the two Cisco Tuning Adaptors associated with my two TIVO's have been restarting by themselves. For a while they were synchronized i.e. they both rebooted at the same time. Now they both have a mind of their own. Every time a TA restarts, the TIVO gives up on any recordings and interrupts any viewing with messages about the TA. You get a second message once the TA restarts, also with terminated recordings.Reboot time varies a lot. Sometimes a couple times a day, sometimes 2 or 3 times a week. Often during the 4th quarter of a Suns or Warriors basket ball game. This is getting old.Cox has been out 4 times. Replaced both tuning adaptors and cable cards. No change. They have blamed it on noise issues, aka ingress (first guy). In house cabling - second guy who replaced every connector he could find. No change. Third guy blamed my amplifier and installed his own. Fourth guy blamed the amplifier installed by the third guy. He replaced it with a mid split amplifier. No change.Problem remains with no significant change. Very difficult to test since it takes between 12 and 36 hours for a TA to reboot on its own.Guy number 5 is now scheduled to come out. Perhaps he will have better luck.
My head is spinning. Smells like a head end issue to me. Is it just coincidence that these problems began with the death of the 1000 series channels, increased modem speed and the death of VOD?
And just today, they have suddenly been rebooting in synchronization. Three times so far. Both rebooted within seconds of one another....Any suggestions would be appreciated.
Same Here. I'm in Phoenix, AZ, connected to the Chandler Headend. I have Cisco Tuning Adapters and My Three (3) TAs have been randomly rebooting since November 2021. It happens at least twice a week, sometimes twice a day. They rebooted tonight at 7:10PM (Arizona Time).
I also would like some explanation and a way to find a resolution. It is very annoying and I'm missing recordings because of it.
My signals are fine and there is no ingress or egress on my line, as of a few months ago when a Cox tech was out to check for ingress/egress.
Here are the Serial Numbers of my TA's, if someone would please look into this.
Serial #: SABSHNQQFSerial #: SABVRMRXXSerial #: SABWWRMXN
There definitely is a problem with the Chandler Headend, My EAS Test Messages should be for Maricopa/Pinal County, but they are not.They specifically all say Pima/Cochise County.