Read the forum guidelines
I received an email that states that starting on 12/1/21 phones connected to the Tel2 connector of the modem will not be able to complete calls and that I should check my phone modem and move the phone connection to Te1 if it is currently connected to Tel2. My phone is connected to Tel2 and when I move it to Tel1 I do not get a dial tone. Is there a reset procedure that I am supposed to perform after switching the connection? I have an Arris TM-3402A which is only used for phone (I have another modem that is used for internet).
Thanks,Dean
You can either reboot the 3402A by pulling its power cord for a few seconds, or you could log into your Cox account and reset the 3402A.
I don't mean a Factory Reset...if this is possible on a telephone modem...by pushing its recessed button somewhere on the modem but instead a network reset from your Cox account.
Try that and if it doesn't work, update us.
Okay, I switched to Tel1 and did the power reset (power down for a few minutes then plug it back in). No dial tone on Tel1, but Tel2 is working. Then I tried the 'network" reset (via the Cox website) and again Tel1 does not work but Tel2 works just fine. Any ideas where to go from here?
Thanks for the info. The email from Cox made it sound like both Tel1 and Tel2 are active and that you just need to switch your connection. Not so. I will put in the request for re-provisioning (via email). Thanks!