Forum Discussion

Karen_Newhouse's avatar
Karen_Newhouse
New Contributor
4 years ago

URC 8820 remote control does not support Denon receiver AVR-X1600H

This is a 2019 model Denon.  I cannot get it to turn off and on with the Cox remote control.  It's the 3rd receiver we've had.  Both of the others worked fine with the Cox remote control.  
Bruce's avatar
Bruce
Honored Contributor III

My bad...OP did provide the remote.

I found a few codes...

Denon
1360
1460
2134
2279
2516
2706
2820
2857
3347
3380

Karen_Newhouse's avatar
Karen_Newhouse
New Contributor
4 years ago

2134 is the correct number, but the receiver switches to tuner mode when powered on.

  • Bruce's avatar
    Bruce
    Honored Contributor III
    4 years ago

    To be honest, I'm unsure which "receiver" is new:  the cable-box or the Denon.

    If the Denon is new, this would be an initial setup and we can work through this.  If it's another cable-box, it's usually the authentication within the daisy-chain of HDMI cables causing an issue.

    Which receiver is the new device?

    • Karen_Newhouse's avatar
      Karen_Newhouse
      New Contributor
      4 years ago

      It's the Denon that's new.  I missed code 3136.  That does work slightly better.  The TV volume needs to kick in when the receiver is off.

      • Bruce's avatar
        Bruce
        Honored Contributor III
        4 years ago

        I'm glad 3136 works better.

        For TV volume, it depends how you have your cable-box wired.  If it's HDMI to the Denon, the audio should "pass-through" with the video when turned off.

        If you're wired to the TV...such as via eARC...there should be an audio setting within the TV to auto-detect an external audio connection.  If none detected (turned on), the TV should process the audio.