Welcome to the Cox Community
Our community is a collaborative place to learn about Cox products and services. Jump into the conversation today!
Messages
Selected Messages
New Contributor
•
Can a URC-8820-MOTO replace a URC-8820-CISCO
It looks like I have a Motorola Remote but a Cisco Box. It does not control the Set Top Box. Is there a way to configure this?
Accepted Solution
ReneeG
Former Moderator
•
You can follow these steps to reprogram the remote to the Cisco receiver:
1. While aiming at the receiver, press and release the CABLE button.
2. Hold down SWAP & A together until the CABLE key blinks twice.
The remote should now control the cable box. Please let us know if this helps.
0
0
LVAuctioneer
New Contributor
•
Thank you. After some further research, I was able to solve this following *almost* the same steps. SWAP+A & SWAP+B was able to do the trick. Thanks for assistance.
0
0
ReneeG
Former Moderator
•
0
0