URC8820 remote

Shouldn't normally be necessary, so this isn't an official procedure (and isn't even listed on the support site at http://www.urcsupport.com/html.php?page_id=761 ) but this seems to work:

-Hold down mute+select until the last selected device key blinks twice.
-Enter 9 8 1.
-The "cable" button should blink four times.
-Programming is now reset.

If necessary, you can take your remote to a Solution Store and swap it out at any time.

Thanks a lot. That fixed the issue that I was having. The volume control would not work when cable was selected. I had to select tv button to adjust volume, then go back to cable to do anything else.