Welcome to the Cox Community
Our community is a collaborative place to learn about Cox products and services. Jump into the conversation today!
Messages
Selected Messages
New Contributor
•
Control volume on Anthem receivers
Anthem is not listed in the setup section for controlling an AV Receiver with your Cox Contour 2 remote. Is there any way Anthem remote codes could be added?
MichaelJ
Moderator
•
0
0
imahawki
New Contributor
•
No dice for me. After following the steps I probably pressed the channel up button 50 times but it never powers down the receiver. There is nothing special about the receiver. It uses regular IR codes. Its just a high end brand.
0
0
MichaelJ
Moderator
•
0
0
imahawki
New Contributor
•
There are no codes in the manual and the steps you linked to above do not ever result in the receiver being turned off so I'm at a loss.
I called Anthem and they told me that COX would have to have the remote programmed on their end. Its nothing that they can control at all because the remote manufacturer has to program the remote with the right code and the 5 digit codes you enter are arbitrary and set by the manufacturer of the remote to denote certain brands.
0
0
MichaelJ
Moderator
•
0
0
imahawki
New Contributor
•
They list the hex codes for professional custom installers type of remotes. These codes are dozens of characters long for each and every command. They're not like the 5 digit codes COX uses to tell the remote what brand you have.
https://www.anthemav.com/downloads/AVM60-MRXx20-IR-hex.xlsx
0
0