This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Panoramic + Mesh

I am getting my Cox instal in 10 days. I currently use the new Netgear Nighthawk MK63 mesh system with slow dal - but the mesh works great with it.  How do you set up the Panoramic with a mesh system?  Can you turn the radio of which is what I do now or go to bridge mode or both?  Thanks in advance for you help.

UPDATE:  Well, it turns out they are going to need to due a complete new cable install.  With city approvals, blue staking and digging it will be 2-3 months before I have Cox cable.  Bummmmmer

Parents
  • I disabled the 2.4 and 5ghz radios, and just plugged the primary mesh router into one of the panoramic modem ports. Putting the modem into bridge mode was a terrible idea, as it disables all but one of the ethernet ports, and nothing else hard-wired to the modem will work. Just disabling the radios worked great, and the CoxWifi hotspot still works, allowing you to feed some devices on the hotspot and not get dinged for usage. 

Reply
  • Putting the modem into bridge mode was a terrible idea, as it disables all but one of the ethernet ports, and nothing else hard-wired to the modem will work

    That is the point of the gateway in bridge mode, which is to pass all traffic for 1 IP address. You then assign that IP address to your router via DHCP. This is why it's important to power cycle the gateway after you put it in bridge mode. Besides, the gateway only has two ethernet ports anyway, your only losing one and get 4 in your router.

Children
No Data