Forum Discussion

JimG's avatar
JimG
New Contributor

ipv6 enable

I have an sb6141 and a netgear r6220 with ipv6 enabled. How do I get the modem to allow ipv6, it reports ipv4 only?

4 Replies

Sort By
Most LikedOldestNewest
Replies have been turned off for this discussion
  • wees41's avatar
    wees41
    Contributor II

    I was told ip mode doesn't matter in the cable modem status just make sure router is ipv6

  • DerrickW's avatar
    DerrickW
    Valued Contributor
    I would like to check the firmware on the modem, make sure you have the most recent version. Can you please send an email with a link to this forum post, and your account information? I'll look into this for you.
  • JimG's avatar
    JimG
    New Contributor

    Derrick, I do not see how to get your email address.

  • Becky's avatar
    Becky
    Moderator
    Hi Jim,

    I'm sorry about that! Our email address is Cox.Help@cox.com.