Forum Discussion

AZJatt's avatar
AZJatt
New Contributor

IPV4 and IPV6

Hi I have 300MB internet service and thinking of buying new Surfboard Modem SB8200 with two gigabit ports. I would like to know whether I can use both ports but I need to know whether cox supports IPV4 and IPV6 in AZ. Is any cost to use both ports? Thanks
cox support

3 Replies

Sort By
Most LikedOldestNewest
Replies have been turned off for this discussion
  • ChrisL's avatar
    ChrisL
    Former Moderator
    @AZJatt

    Dual stack is supported on residential connections. Only 1 Ethernet will be active on that device at this time.

  • anuraj1's avatar
    anuraj1
    New Contributor

    Well that stinks, I just bought an SB8200 as well. I was hoping to connect my wireless router to one ethernet port and a direct connection to my office computer using the other port.

  • ChrisL's avatar
    ChrisL
    Former Moderator
    @anuraj1

    For what it's worth even when it's enabled that setup would not work. The purpose of the 2nd port is for LACP which basically allows you to double the Ethernet path bandwidth to a single device on the other end that also supports LACP.