Connecting to Router Settings for NetGear CG3000D

Connecting to Router Settings for NetGear CG3000D

Internet Forum

Activity: 5 Replies | 2 Subscribers

This question is still unresolved
Posted by

I cannot seem to connect to my COX-provided NetGear CG3000D router's settings.  I am having issues with getting my Nintendo Wii to connect to the internet and it recommends changing some network settings via my router.

The manual for the router available through COX.com says to access the setting by going to http://192.168.0.1 but this does not load anything for me.

Thank you for any advice.

 

All Replies
  • Posted by ChrisL
    24 Jan 2013 7:58 AM

    That is the correct process so it sounds like something isn't working as it should.  It may be worth resetting the device to defaults by pushing the reset button and trying again.

    -Chris

    Cox Support Forums Moderator

  • Posted by johnmb
    23 Feb 2013 12:30 AM

    I am having the same issue.  I loose ability to access the router settings using the http://192.168.0.1 address, so I am forced to do a hard reset.  I then edit the settings using the restored default address to my SSID.  The router will function normally, and then I will loose setup access again (from network genie and browser) and know the problem has returned.    It might be coincidental, but my VPN connection quits allowing me to connect through it to remote computers at the same time.  The VPN connection will connect properly, but I am unable to see any of the servers I normally work on.  After a reset, the connections will also begin working normally.  Netgear was helpless, and going to the closet to reset the router every time I need to access settings or access a server thru VPN is getting very old.  

    Is there any chance that an update is being pushed down, or would this not effect the restored capabilities after a reset?  An chance a firmware update could help?

  • Posted by ChrisL
    23 Feb 2013 6:54 AM

    VPN server visibility could be DNS related.  Try setting your DNS servers on the PC to 68.105.28.13 and 68.105.29.13 to see if that helps.

    -Chris

    Cox Support Forums Moderator

  • Posted by Rodhess
    24 Feb 2013 5:25 PM

    I'm experiencing the same issue.  I could connect using the admin/password when I first installed the modem.  I changed the password and it worked fine for a day.  Now I can't login to the web management.  I reset it to factory defaults, but that didn't work either.

    What's up?  Did you change the admin password?

  • Posted by ChrisL
    26 Feb 2013 6:55 AM

    Did you hold the reset button on the router for 30 seconds to reset it?

    -Chris

    Cox Support Forums Moderator