Volume Control Client
In a previous post I described my system where the HDMI output of the client goes directly to a ViewSonic monitor with the audio portion split off and sent to powered speakers. My previous setups (be...
Forum Discussion
Hi there, during the initial set-up you will be asked if you're using an external audio system so that it can be included; however, the Contour 2 remote doesn't allow controlling the volume without it being paired to its receiver. -Thanks, Carol
Thanks for the disappointing answer.
I pretty much figured out that was the case. Is this something built into the hardware/firmware or can it be flagged as a bug for a number of non-traditional users that can be fixed?
- This is something that would have to be in the hardware or firmware. These boxes were not intended to have volume control built into them.
Brian
Cox Support Forum Moderator
